Most magnetic card holders get sold in bulk packs, which makes sense for collectors protecting an entire binder's worth of cards. That is overkill when there is really only one card that needs it.
Buying a single magnetic one touch, sized correctly to the specific card, avoids paying for a stack of holders that will sit unused.
This guide covers when an individual purchase makes more sense than a bulk pack and how sizing works across the 35pt to 180pt range.
A bulk pack of magnetic one touch holders is efficient per unit, but it assumes a collector needs several at the same thickness. That is rarely true for someone protecting a single graded pull, a personal grail, or a card being sold individually.
Buying one holder sized exactly to that card avoids the cost of a full pack and the clutter of unused holders sitting in a drawer.
Magnetic one touch holders are sized by point thickness, which corresponds to the card's own thickness rather than its width or height. A standard single card typically sits around 20 to 35pt, while cards with foil stamping, thicker stock, or memorabilia inside can run considerably higher.
Choosing the wrong thickness either leaves a card loose and able to shift inside the holder, or forces a card that is too thick to close properly, both of which risk damage over time.
For collectors who need one holder sized correctly rather than a bulk pack, EVORETRO's Magnetic One Touch Card Holder is available individually across the 35pt to 180pt range, so the fit matches the card rather than the other way around.
A bulk pack makes sense for a collector actively processing many cards at a similar thickness, like a full binder of base cards being upgraded to magnetic holders at once. Buying in bulk lowers the per-unit cost for that kind of volume.
An individual purchase makes more sense for a single standout card, a specific grade result, or a card being prepared for sale where only one holder is needed and buying extra would be wasted spend.
The safest way to pick a thickness is to measure the card itself with calipers if possible, rather than guessing based on card type. Point thickness is measured in thousandths of an inch, and even cards from the same set can vary slightly depending on foil or texture treatments.
When in doubt, sizing up slightly is safer than sizing down, since a holder that is a touch loose is less risky than one that has to be forced shut around a card that is too thick.
Collectors who eventually need several thicknesses often build that range one holder at a time rather than buying an entire multi-size bulk box upfront. As new cards come in at different thicknesses, adding a single matching holder keeps the collection accurately protected without excess inventory.
This approach also works well for collectors who only occasionally need magnetic holders, since it avoids tying up money in sizes that might sit unused for months.
Yes, this holder is sold individually across its full size range.
Most standard cards fall in the 20 to 35pt range.
Measuring the card with calipers gives the most accurate result; when unsure, sizing up slightly is the safer choice.
It is available individually from 35pt up to 180pt.
Yes, higher point thicknesses like 180pt are typically for thicker memorabilia or patch cards.
No, a correctly sized holder closes evenly without adding stress to the card itself.
Per unit, yes, but for a single card it avoids paying for holders that would otherwise go unused.
Yes, as long as the new card matches the same point thickness.
Yes, many collectors use correctly sized one touch holders when preparing raw cards for shipping or grading.
The card may not close flush, and forcing it shut risks bending or creasing the card.
Yes, thicker holders generally cost slightly more due to the added material.
Yes, since holders are sold individually, you can buy exactly the mix of sizes your cards require.
A single card deserves a holder sized to it, not a bulk pack bought out of habit. Getting the point thickness right protects the card and avoids wasted spend on holders that never get used.
If you have one card that needs the right fit, start with EVORETRO's Magnetic One Touch Card Holder and pick the size that actually matches it.
!
